lure making

Lureless · Post by **Lureless** » Sun Feb 11, 2007 5:11 pm

Anyone have some leads to lure making information? I started carving some but not sure what to use for the epoxy and eye screws. Its still cold and the tackle box can't get anymore organized. Time to try something new. Thanks

Kingfisher · Post by **Kingfisher** » Mon Feb 12, 2007 12:55 pm

Lureless, try these couple places for hard ware and such. www.staminainc.com and www.jannsnetcraft.com these are both good sources for low volume components. They are component retailers. you can get catalogs mailed to you from both places. As for top coat epoxy I use Envirotec light . Menards carries it. For gluing lips in I use Super glue brand 4 to 6 minute two part epoxy( red plungers) . hope this helps. Kingfisher

Post by **Will Schultz** » Mon Feb 12, 2007 1:16 pm

You can learn tons by just looking through the topics on this forum:

http://muskie.outdoorsfirst.com/board/f ... asp?fid=25

Moski · Post by **Moski** » Mon Feb 12, 2007 4:42 pm

Try this site http://www.tackleunderground.com/

Brad

Lureless · Post by **Lureless** » Tue Feb 13, 2007 7:59 pm

Thanks for the leads.

Lureless · Post by **Lureless** » Wed Feb 14, 2007 9:04 am

Are the eye screws the same as the ones at the hardware store. Or are the ones they sell any stronger?

Post by **Will Schultz** » Wed Feb 14, 2007 9:14 am

Lureless wrote:Are the eye screws the same as the ones at the hardware store. Or are the ones they sell any stronger?

Stainless steel 1.25" to 1.5" eyescrews might be hard to find at a hardware store.

LeMay · Post by **LeMay** » Thu Mar 01, 2007 1:29 pm

Lureless Here is a good link I just found. Follow the link and them go down to Lure Building.

http://www.stripersonline.com/surftalk/index.php

Michigan Muskie Alliance

lure making

lure making

Supplies

lures

Thanks